Publicación: A MIP-based flow-through fluoroimmunosensor as an alternative to immunosensors for the determination of digoxin serum samples
Cargando...
Fecha
2009-01-09
Autores
Editor/a
Director/a
Tutor/a
Coordinador/a
Prologuista
Revisor/a
Ilustrador/a
Derechos de acceso
info:eu-repo/semantics/openAccess
Título de la revista
ISSN de la revista
Título del volumen
Editor
Springer
Resumen
This work reports a comparative study of two automated flow-through fluorosensors for the determination of digoxin in serum samples: an immunosensor with an anti-digoxin polyclonal antibody as the reactive phase permanently immobilized on CPG, and a sensor with a selective reaction system based on a methacrylic molecularly imprinted polymer (MIP) synthesized by bulk polymerisation. The variables affecting the sensitivity and dynamic range of the sensors (e.g., the carrier and elution solutions, flow-rates, pH and reagent concentrations) were optimised and the binding characteristics of their reactive phases compared in a competitive fluorescent assay. Digoxin was reproducibly determined by both sensors at the mg L-1 level (detection limit= 1.20×10-3 mg L-1 and RSD= 4-7% for the immunosensor; detection limit= 1.7×10-5 mg L-1 and RSD= 1-2% for the MIP sensor). No cross reactivity with digoxinrelated compounds was seen for either sensor at a digoxin:interferent ratio of 1:100. The lifetime of the immunosensor was about 50 immunoassays; its shelf life, when unused, is about three months. The lifetime of the MIP sensor was over 18 months. Both sensors were used to determine the digoxin concentration of human serum samples with satisfactory results.
Descripción
Categorías UNESCO
Palabras clave
Digoxin, Permanent immobilization, Molecular imprinting, Flow-through fluorosensor, Serum analysis
Citación
Centro
Facultad de Ciencias
Departamento
Ciencias Analíticas