Publication: Estudio biomecánico de implantes de tórax obtenidos por fabricación aditiva
No Thumbnail Available
Date
2022
Editor
Director
Advisor
Coordinator
Commentator
Reviewer
Illustrator
Access rights
info:eu-repo/semantics/openAccess
Journal Title
Journal ISSN
Volume Title
Publisher
Universidad Nacional de Educación a Distancia (España), Universidad Politécnica de Madrid. Departamento de Ingeniería Mecánica
Abstract
Los defectos torácicos, que llegan a abarcar las costillas, cartílagos costales y esternón, suelen ser el resultado de la resección de tumores primarios de la pared torácica o de lesiones con metástasis. El avance de la tecnología de impresión 3D permite la producción de soluciones complejas que se pueden adaptar a la ubicación de la zona dañada. El Instituto Tecnológico de Canarias (ITC) y el Biomaterials and Biomechanics Research Group (BBRG), adscrito al Departamento de Ingeniería Mecánica de la Universidad de Las Palmas de Gran Canaria (ULPGC) trabajan en el diseño y desarrollo de prótesis torácicas flexibles basadas en estructuras de resorte. En este estudio se analiza, computacionalmente y experimentalmente, el comportamiento biomecánico de implantes de tórax de aleación de titanio fabricados con la tecnología de fusión por haz de electrones, en inglés Electron Beam Melting (EBM). Estos implantes sustituyen al conjunto de costillas y cartílagos costales lográndose con su diseño obtener características flexibles, similares al tórax humano, y permitiendo la correcta función de respiración.
Thoracic defects, which may involve the ribs, costal cartilages, and sternum, usually result from resection of primary chest wall tumors or metastatic lesions. The advancement of 3D printing technology allows the production of complex solutions that can be tailored to the location of the damaged area. The Instituto Tecnológico de Canarias (ITC) and the Biomaterials and Biomechanics Research Group (BBRG), belonging to the Department of Mechanical Engineering of the University of Las Palmas de Gran Canaria (ULPGC) are working on the design and development of flexible thoracic prostheses based on structures spring. In this study, the biomechanical behavior of titanium alloy thoracic implants manufactured with Electron Beam Melting (EBM) technology is analyzed computationally and experimentally. These implants replace the set of ribs and costal cartilages, achieving with their design flexible characteristics, similar to the human thorax, and allowing the correct breathing function.
Thoracic defects, which may involve the ribs, costal cartilages, and sternum, usually result from resection of primary chest wall tumors or metastatic lesions. The advancement of 3D printing technology allows the production of complex solutions that can be tailored to the location of the damaged area. The Instituto Tecnológico de Canarias (ITC) and the Biomaterials and Biomechanics Research Group (BBRG), belonging to the Department of Mechanical Engineering of the University of Las Palmas de Gran Canaria (ULPGC) are working on the design and development of flexible thoracic prostheses based on structures spring. In this study, the biomechanical behavior of titanium alloy thoracic implants manufactured with Electron Beam Melting (EBM) technology is analyzed computationally and experimentally. These implants replace the set of ribs and costal cartilages, achieving with their design flexible characteristics, similar to the human thorax, and allowing the correct breathing function.
Description
UNESCO Categories
Keywords
Fabricación aditiva, reconstrucción de tórax, implante a medida, Ti-6Al-4V
Citation
Center
E.T.S. de Ingenieros Industriales
Department
Mecánica