Publicación: Caracterización estadística de una espuma de aluminio utilizando ensayos de compresión
Fecha
2024-10-22
Editor/a
Director/a
Tutor/a
Coordinador/a
Prologuista
Revisor/a
Ilustrador/a
Derechos de acceso
info:eu-repo/semantics/openAccess
Título de la revista
ISSN de la revista
Título del volumen
Editor
Universidad Nacional de Educación a Distancia (España), Universidad de Concepción - Chile. Departamento de Ingeniería Mecánica
Resumen
En este trabajo se estudia la respuesta mecánica de probetas de espuma de aluminio mediante ensayos de compresión siguiendo la norma ISO13314. Para este propósito, y a partir de un solo bloque rectangular de espuma, se extraen 36 probetas con dos geometrías, cilíndrica y paralelepipédica, cerca del borde de la muestra y de su parte central. Con el fin de comprobar si la geometría de las probetas y la zona de su extracción influencian las propiedades mecánicas, se plantean seis hipótesis, las cuales son analizadas por métodos estadísticos. Los diagramas de tensión-deformación obtenidos señalan tres comportamientos esperados de los materiales celulares: la zona elástica, la zona de Plateau y la zona de densificación. Se observa que, independientemente de la forma y ubicación de las probetas, las densidades y propiedades mecánicas (esfuerzo de Plateau, esfuerzo máximo de compresión, módulo de Young y capacidad de absorción de energía) son estadísticamente similares.
In this work, the mechanical behavior of aluminum foam specimens is studied through compression tests following the ISO13314 standard. For this purpose, and from a single rectangular block of foam, 36 specimens with two geometries, cylindrical and parallelepiped, are extracted near the edge of the cellular structure and its central part. To verify whether the geometry of the specimens and the area of their extraction influence the mechanical properties, six hypotheses are proposed, which are then analyzed by statistical methods. The stress-strain diagrams obtained show the three expected regions for cellular materials: the elastic zone, the Plateau zone, and the densification zone. It is observed that, regardless of the shape and location of the samples, the densities, and the mechanical properties (Plateau stress, maximum compression stress, Young's modulus and energy absorption capacity) are statistically similar.
In this work, the mechanical behavior of aluminum foam specimens is studied through compression tests following the ISO13314 standard. For this purpose, and from a single rectangular block of foam, 36 specimens with two geometries, cylindrical and parallelepiped, are extracted near the edge of the cellular structure and its central part. To verify whether the geometry of the specimens and the area of their extraction influence the mechanical properties, six hypotheses are proposed, which are then analyzed by statistical methods. The stress-strain diagrams obtained show the three expected regions for cellular materials: the elastic zone, the Plateau zone, and the densification zone. It is observed that, regardless of the shape and location of the samples, the densities, and the mechanical properties (Plateau stress, maximum compression stress, Young's modulus and energy absorption capacity) are statistically similar.
Descripción
Organizado y patrocinado por: Federación iberoamericana de Ingeniería Mecánica y Universidad de Concepción - Chile. Departamento de Mecánica, FeIbIm – FeIbEM
Categorías UNESCO
Palabras clave
espuma aluminio, test de compresión, propiedades mecánicas, representatividad estadística, aluminum foam, compression test, mechanical properties, statistical analysis
Citación
-
Centro
E.T.S. de Ingenieros Industriales
Departamento
Mecánica