Persona: Paniagua González, Gema
Cargando...
Dirección de correo electrónico
ORCID
Fecha de nacimiento
Proyectos de investigación
Unidades organizativas
Puesto de trabajo
Apellidos
Paniagua González
Nombre de pila
Gema
Nombre
7 resultados
Resultados de la búsqueda
Mostrando 1 - 7 de 7
Publicación Assessment of the impact of aquaculture facilities on transplanted mussels (Mytilus galloprovincialis): Integrating plasticizers and physiological analyses as a biomonitoring strategy(Elsevier, 2022-02-15) Rios Fuster, Beatriz; Alomar, Carme; Capó, Xavier; Silva, Mónica; Solé, Montserrat; Freitas, Rosa; Deudero, Salud; Paniagua González, Gema; Soliz Rojas, Dulce Lucy; Fernández Hernando, Pilar; Garcinuño Martínez, Rosa MªThe growing plastic production and its continuous use is a significant problem. In addition, aquaculture practices have experienced a considerable growth and plastic is widely used in these activities, hence plasticizers must be considered due to their potential ecotoxicological impacts on species. Mussels placed inside an Integrated Multi-Trophic Aquaculture (IMTA) system and at two control locations were employed to quantify the ingestion of anthropogenic particles and associated chemical plasticizers, such as bisphenol A (BPA) jointly to bisphenol F (BPF) and bisphenol S (BPS), and phthalates represented by diethyl phthalate (DEP), dibutyl phthalate (DBP) and bis(2-ethylhexyl) phthalate (DEHP). In addition, some metabolism and oxidative stress related parameters were measured in mussels’ whole soft tissue. Anthropogenic particle ingestion of mussels increased over time at the three locations and the following order of abundance of pollutants was observed: BPA> BPF> DEHP> DBP> BPS> DEP. Even though no differences according to location were found for pollutants’ occurrence, time trends were evidenced for BPA and DEHP. On the other hand, a location effect was observed for biomarkers with highest values detected in mussels located at the vicinities of the aquaculture facility. In addition, a reduced detoxification activity was observed over time parallel to BPA decrease.Publicación Enhancement of a Simple, Economic and Eco-Friendly Analytical Approach for the Extraction and Determination of Endocrine Disruptors from Plastics in Shrimp(MDPI, 2024-07-12) Soliz Rojas, Dulce Lucy; García González, Jorge; Paniagua González, Gema; Garcinuño Martínez, Rosa Mª; Bravo Yagüe, Juan Carlos; Fernández Hernando, PilarThe economic significance of the shrimp industry relies heavily on the comprehensive utilization of all of the shrimp’s parts. However, this importance is often threatened by common challenges such as disease and pollution, caused by prominent contaminants that are capable of exerting adverse effects either directly as physical pollutants or indirectly through the incorporation of additives or adsorbed chemicals. Among these substances are endocrine disruptors, which pose risks to both wildlife and human populations. In this study, 11 endocrine-disrupting compounds were determined (3 bisphenols, 3 phthalates, 3 pesticides, and 2 nonylphenols) through the development of a cost-effective, greener and cost-friendly method based on solid-phase matrix dispersion (MSPD) with high-performance liquid chromatography coupled with diode array detection (HPLC-DAD). Determinations were performed on different parts of the shrimp: the cephalothorax, abdomen, intestine and shell. Several variables were optimized in the extraction, separation and detection phases, resulting in average recoveries of about 90%. The limit of detection (LOD) varies depending on the analyte and matrix. At concentrations of 1 mg/kg in the cephalothorax+shells and 1.25 mg/kg in the abdomen+intestine, all compounds were detected, except for nonylphenols. The developed method has allowed the simultaneous determination of 11 endocrine disruptors in different parts of the shrimp samples. Furthermore, the MSPD has been demonstrated to be an efficacious, selective, and streamlined sample extraction method, eliminating the necessity for pretreatment steps such as centrifugation and filtration, as well as the use of large volumes of solvents.Publicación Identification and morphological characterization of different types of plastic microparticles(Elsevier, 2024-05-15) Soliz Rojas, Dulce Lucy; Paniagua González, Gema; Muñoz Arnanz, Juan; Bravo Yagüe, Juan Carlos; Fernández Hernando, Pilar; Garcinuño Martínez, Rosa MªThe knowledge of the polymeric composition of microplastics (MPs) is interesting because offers useful information on the resistance, durability, and degradability of these materials, also allowing progress in the control of this contamination. However, there is currently a lack of reliable standardized methods for the identification, and characterization of the plastic microparticles. This work uses different techniques in a complementary manner for the identification, and characterization of MPs that more frequently are found in the environment. A total of 10 types of plastics were collected (polystyrene (PS), polyethylene terephthalate (PETE), polyethylene (PE), high- and low-density polyethylene (HDPE and LDPE, respectively), polyvinyl chloride (PVC), polypropylene (PP), polytetrafluoroethylene (PTFE), Polyamide (PA, Nylon 6,6) and poly-carbonate (PC)) and their chemical identification were analyzed by reflectance-attenuated infrared (FTIR-ATR). Furthermore, the samples were observed using light microscopy, and scan-ning electron microscopy (SEM). Also, staining with 12 different dyes was performed to improve the identification of microplastics. The results of this study revealed that PETE, PE, HDPE and LDPE, whose SEM images exhibited smoothness and flat uniformity of their surface, were not (or less) susceptible to adsorb staining solutions while PP, PA, PVC, and PTFE, were capable of adsorbing the dye solutions.Publicación Quantification of differential tissue biomarker responses to microplastic ingestion and plasticizer bioaccumulation in aquaculture reared sea bream Sparus aurata(Elsevier, 2022-08) Capó Fiol, Xavier; Alomar, Carme; Compa, Monserrat; Solé, Montserrat; Sanahuja, Ignasi; Deudero, Salud; Soliz Rojas, Dulce Lucy; Paniagua González, Gema; Garcinuño Martínez, Rosa MªMarine aquaculture is considered a potential source of microplastics (MPs). MPs can induce oxidative stress and damage in marine species. In this study we evaluated the impact of MPs intake in the commercial fish, Sparus aurata , from aquaculture facilities and the antioxidant response associated to this MPs ingestion in caged specimens for 120 days. Sampling was carried out at the beginning of the study T 0 at 60 days (T 60 ) and at 120 days (T 120 ). At each sampling stage, gastrointestinal tract, blood, plasma, liver and muscle samples were obtained to analyse MPs intake (gastrointestinal tract), oxidative stress markers (blood, plasma and liver) and plasticizers bioaccumulation (muscle). Fish sampled at T 60 presented the highest MPs intake and plasticizers accumulated in muscle over time, but with a different pattern according to type: bisphenols and phthalates. This indicates MPs ingestion induces a differential tissue response in S. aurata . Similarly, stress biomarkers presented a differential response throughout the study, depending on the analysed tissue. In the case of oxidative damage markers, for malondialdehyde (MDA) an increase throughout the study was observed both in liver and blood cells but with a progressive decrease in plasma. In the case of phase I detoxifying enzyme activities in liver, 7-ethoxyresorufin O-deethylase (EROD), 7-benzyloxy-4-[trifluoromethyl]coumarin-O-debenzyloxylase (BFCOD) and carboxylesterases (CE), showed a comparable decrease at T 60 with a slight recovery at T 120 . In contrast, glutathione- S -transferase (GST) activity was significantly enhanced at T 60 compared to the other sampling stages. In conclusion, MPs ingestion occurs in aquaculture reared seabream where potentially associated plasticizers accumulate in the muscle and both could be responsible for plasma and liver oxidative stress damage and alterations on detoxifying biomarkers responsesPublicación Occurrence of common plastic additives and contaminants in raw, steamed and canned mussel samples from different harvesting areas using MSPDHPLC methodology(Elsevier, 2024-04) Garrido Gamarro, Esther; Soliz Rojas, Dulce Lucy; Paniagua González, Gema; Fernández Hernando, Pilar; Garcinuño Martínez, Rosa MªMicroplastics are a complex mix of chemicals containing polymers and certain plastic additives such as bisphenols and phthalates. These particles are porous materials that can also sorb contaminants from their surroundings, and leach chemicals from the particle under certain circumstances. Aquatic animals can ingest microplastic particles, which mostly bioaccumulate in the gastrointestinal tract of animals. In terms of dietary exposure, small animals consumed whole such as mussels, contribute more to the dietary intake of microplastic particles. Plastic additives and contaminants are not chemically bound to the polymers, and certain processing methods or cooking processes result in the release of these chemicals that leach from the plastic particles, leaving them more available for absorption when ingested. Analytical methods are crucial for a better understanding of the occurrence of plastic additives and contaminants in aquatic products, and to know certain circumstances and treatments that influence human exposure. This study uses an MSPD-HPLC methodology for the simultaneous determination of 9 analytes (BPA, BPF, BPS, DEP, DBP, DEHP, DDD, DDT, and DDE) analyzing, for the first time, the occurrence of these chemicals in raw, steamed and canned mussels of two different harvesting areas (Atlantic and the Mediterranean), becoming one of the most efficient methodologies for determining the presence of these analytes in very complex food matrices, able to define the changes in cooking and processing activities. The results showed that the heat and pressure treatment could influence the migration of plastic additives from microplastic particles present in mussels to the cooking liquids.Publicación Assessing microplastic ingestion and occurrence of bisphenols and phthalates in bivalves, fish and holothurians from a Mediterranean marine protected area(Elsevier, 2022-08-07) Rios Fuster, Beatriz; Alomar, Carme; Deudero, Salud; Paniagua González, Gema; Soliz Rojas, Dulce Lucy; Fernández Hernando, Pilar; Garcinuño Martínez, Rosa MªMicroplastic (MP) ingestion, along with accumulated plasticizers such as bisphenol A (BPA), bisphenol F (BPF), and bisphenol S (BPS), and phthalates represented by diethyl phthalate (DEP), dibutyl phthalate (DBP) and bis (2-ethylhexyl) phthalate (DEHP), were quantified in bivalves, fish, and holothurians collected from a coastal pristine area at the western Mediterranean Sea. MP ingestion in sediment-feeders holothurians (mean value 12.67 ± 7.31 MPs/individual) was statistically higher than ingestion in bivalves and fish (mean 4.83 ± 5.35 and 3 ± 4.44 MPs/individual, respectively). The main ingested polymers were polyethylene, polypropylene, and polystyrene. The levels of BPS, BPF, and DEHP were highest in bivalves' soft tissue; BPA and DBP had the highest levels in the holothurians’ muscle. In addition, the levels of all plasticizers assessed were lowest in fish muscle; only BPA levels in fish were higher than in bivalves, with intermediate values between those of bivalves and holothurians. This study provides data on exposure to MPs and plasticizers of different species inhabiting Cabrera Marine Protected Area (MPA) and highlights the differences in MP ingestion and levels of plasticizers between species with different ecological characteristics and feeding strategies.Publicación Assessing matrix solid phase dispersion extraction strategies for determining bisphenols and phthalates in gilthead sea bream samples(MDPI, 2024-01) Soliz Rojas, Dulce Lucy; Paniagua González, Gema; Bravo Yagüe, Juan Carlos; Fernández Hernando, Pilar; Garcinuño Martínez, Rosa MªMicroplastics (MPs) and nanoplastics (NPs) are widely spread in the environment, generating significant concern due to their potential impact on environmental health. Marine species usually ingest plastic fragments, mistaking them for food. Many toxic compounds, such as plastic additives that are not chemically bound to the plastic matrix, can be released from MPs and NPs and reach humans via the food chain. This paper highlights the development and validation of a straightforward solid–liquid extraction clean-up procedure in combination with a matrix solid-phase dispersion method using high-performance liquid chromatography coupled with mass spectrometry (HPLC-MS) detection, enabling facile, precise, and reliable identification and quantitation of a total of six bisphenols and phthalates in gilthead sea breams. Under the optimized conditions, the developed method showed good linearity (R2 > 0.993) for all target compounds. The recoveries obtained were between 70 and 92%. The relative standard deviations (RSDs) for reproducibility (inter-day) and repeatability (intra-day) were less than 9% and 10%, respectively. The limit of detection (LOD) and limit of quantification (LOQ) for the target compounds ranged from 0.11 to 0.68 µg/kg and from 0.37 to 2.28 µg/kg, respectively. A new, efficient extraction methodology for the determination of BPA, BPS, BPF, DBP, DEP, and DHEP in gilthead seabream has been optimized and validated.